Bass Fishing Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
5,343 Posts
Discussion Starter · #1 ·
Got on the water about 1:30 pm.  
Water temp 58-61
launched at cp


Fished with Ben_S and threw a few different large cranks, worms, and jigs with no luck.  Ended up figuring out a pattern with a flat a. Caught about 12 fish but 1/2 were dinks.  Biggest was around 6lb.  Probably gonna try it again tomorrow.





 

· Registered
Joined
·
10,147 Posts
Nice Work!

What is a Bomber Flat "A"? :-?

One other note:

Manfield Dam release: 6 am - 10 am; 6pm - 10 pm

"Lake levels are measured at Inks Dam and Tom Miller Dam, and [highlight]may be higher in the upper reaches of lakes Inks and Austin[/highlight]. Routine hydroelectric releases to pass water through lakes Inks and Austin can occur, and can cause rises in water level during normal conditions.  Rises in water level due to hydroelectric releases will be higher in the upper reaches of lakes Inks and Austin.

Lakeside residents should maintain awareness of the lake level and weather forecasts when performing work and take care to remove equipment and tools from the shoreline when not in use. [highlight]LCRA officials emphasize that Lake Austin could be refilled quickly with little or no notice[/highlight] if LCRA is required to provide hydroelectric generating capacity in an emergency.

-----------------------------

Flow in the tributaries to the Highland Lakes remain low and steady and as a result lake inflows are continuing to keep pace with releases and evaporative losses. Releases may be made at Inks Dam, Wirtz Dam and Starcke Dam to maintain lake levels.  Releases will continue to be made at Mansfield Dam.  Releases for downstream users and environmental needs will be made from Lake Austin at Tom Miller Dam.  Releases from Lady Bird Lake through Longhorn Dam are controlled by Austin Energy, the electric utility for the City of Austin"
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top